-
1 высокотемпературная эрозия
Русско-английский физический словарь > высокотемпературная эрозия
-
2 эрозия под воздействием высокой температуры
Русско-английский экологический словарь > эрозия под воздействием высокой температуры
-
3 высокотемпературная эрозия
Oil&Gas technology high-temperature erosionУниверсальный русско-английский словарь > высокотемпературная эрозия
-
4 эрозия от воздействия высоких температур
Quality control: high-temperature erosionУниверсальный русско-английский словарь > эрозия от воздействия высоких температур
-
5 эрозия под воздействием высокой температуры
Engineering: high-temperature erosionУниверсальный русско-английский словарь > эрозия под воздействием высокой температуры
-
6 эрозия при воздействии высоких температур
Astronautics: high-temperature erosionУниверсальный русско-английский словарь > эрозия при воздействии высоких температур
-
7 выравниваться
•These forces level off at a high temperature.
•The current increases with applied potential, until it levels off at a limiting value.
* * *Выравниваться-- The erosion rate was initially high, but quickly leveled off to a steady-state rate.Русско-английский научно-технический словарь переводчика > выравниваться
-
8 кратковременное воздействие со стороны
Кратковременное воздействие со стороны-- Metal erosion was produced by short exposures (< 2 ms) to flowing high temperature reactive gases.Русско-английский научно-технический словарь переводчика > кратковременное воздействие со стороны
-
9 действие электрической дуги, возникающей внутри НКУ распределения и управления
действие электрической дуги, возникающей внутри НКУ распределения и управления
-
[Интент]Параллельные тексты EN-RU
Effects of the electric arc inside switchgear and controlgear assemblies
In the proximity of the main boards, i.e. in the proximity of big electrical machines, such as transformers or generators, the short-circuit power is high and consequently also the energy associated with the electrical arc due to a fault is high.
Without going into complex mathematical descriptions of this phenomenon, the first instants of arc formation inside a cubicle can be schematized in 4 phases:
1. compression phase: in this phase the volume of the air where the arc develops is overheated owing to the continuous release of energy; due to convection and radiation the remaining volume of air inside the cubicle warms up; initially there are temperature and pressure values different from one zone to another;
2. expansion phase: from the first instants of internal pressure increase a hole is formed through which the overheated air begins to go out. In this phase the pressure reaches its maximum value and starts to decrease owing to the release of hot air;
3. emission phase: in this phase, due to the continuous contribution of energy by the arc, nearly all the air is forced out under a soft and almost constant overpressure;
4. thermal phase: after the expulsion of the air, the temperature inside the switchgear reaches almost that of the electrical arc, thus beginning this final phase which lasts till the arc is quenched, when all the metals and the insulating materials coming into contact undergo erosion with production of gases, fumes and molten material particles.
Should the electrical arc occur in open configurations, some of the described phases could not be present or could have less effect; however, there shall be a pressure wave and a rise in the temperature of the zones surrounding the arc.
Being in the proximity of an electrical arc is quite dangerous; here are some data to understand how dangerous it is:
• pressure: at a distance of 60 cm from an electrical arc associated with a 20 kA arcing fault a person can be subject to a force of 225 kg; moreover, the sudden pressure wave may cause permanent injuries to the eardrum;
• arc temperatures: about 7000-8000 °C;
• sound: electrical arc sound levels can reach 160 db, a shotgun blast only 130 db.
[ABB]Действие электрической дуги, возникающей внутри НКУ распределения и управления
Короткое замыкание вблизи больших силовых устройств, таких как трансформаторы или генераторы имеет очень большую мощность. Поэтому энергия электрической дуги, возникшей в результате короткого замыкания, очень большая.
Не вдаваясь в сложное математическое описание данного явления, можно сказать, что первые мгновения формирования дуги внутри шкафа можно упрощенно разделить на четыре этапа:
1. Этап сжатия: на этом этапе объем воздуха, в котором происходит зарождение дуги перегревается вследствие непрерывного высвобождения энергии. За счет конвекции и излучения оставшийся объем воздуха внутри шкафа нагревается. На этом начальном этапе значения температуры и давления воздуха в разных зонах НКУ разные.
2. Этап расширения: с первых мгновений внутреннее давление создает канал, через который начинается движение перегретого воздуха. На этом этапе давление достигает своего максимального значения, после чего начинает уменьшаться вследствие выхода горячего воздуха.
3. Этап эмиссии: на этом этапе вследствие непрерывного пополнения энергией дуги почти весь воздух выталкивается под действием мягкого и почти постоянного избыточного давления.
4. Термический этап: после выхлопа воздуха температура внутри НКУ почти достигает температуры электрической дуги. Так начинается заключительный этап, который длится до тех пор, пока дуга не погаснет. При этом все металлические и изоляционные материалы, вступившие в контакт с дугой, оказываются подвергнутыми эрозии с выделением газов, дыма и частиц расплавленного материала.
Если электрическая дуга возникнет в открытом НКУ, то некоторые из описанных этапов могут не присутствовать или могут иметь меньшее воздействие. Тем не менее будет иметь место воздушная волна и подъем температуры вблизи дуги.
Находиться вблизи электрической дуги довольно опасно. Ниже приведены некоторые сведения, помогающие осознать эту опасность:
• давление: На расстоянии 60 см от электрической дуги, вызванной током короткого замыкания 20 кА, человек может подвергнуться воздействию силы 225 кг. Более того, резкая волна давления может нанести тяжелую травму барабанным перепонкам;
• температура дуги: около 7000-8000 °C;
• шумовое воздействие: Уровень шумового воздействия электрической дуги может достигнуть 160 дБ (выстрел из дробовика – 130 дБ).
[Перевод Интент]Тематики
- НКУ (шкафы, пульты,...)
EN
Русско-английский словарь нормативно-технической терминологии > действие электрической дуги, возникающей внутри НКУ распределения и управления
-
10 вопреки ожиданиям
•Contrary to the expectations the temperature did not fall to the initial value.
•The studies of young animals showed, contrary to the expectations, that some degree of stress in infancy is necessary for the development of normal, adaptive behaviour.
•However, contrary to what you might expect, the erosion velocity is quite high.
* * *Вопреки ожиданиямExperiments in small scale models of various sizes showed that, contrary to expectation, NO х production is independent of the system pressure.Contrary to expectations, no such vanadium compounds were detected in the oxide coating.Contrary to what would be expected, the next larger step (t = 0.72) has a lesser effect upon the flow than was experienced for t = 0.61.Русско-английский научно-технический словарь переводчика > вопреки ожиданиям
-
11 вопреки ожиданиям
•Contrary to the expectations the temperature did not fall to the initial value.
•The studies of young animals showed, contrary to the expectations, that some degree of stress in infancy is necessary for the development of normal, adaptive behaviour.
•However, contrary to what you might expect, the erosion velocity is quite high.
Русско-английский научно-технический словарь переводчика > вопреки ожиданиям
-
12 считаться
Считаться - to be regarded as, to be deemed, to be viewed; to be reckoned to be, to be thought to be, to be understood to be, to be believed to be, to be expected to be, to be considered (рассматриваться); to be reckoned with (учитываться)The solid was regarded as being ready for a data run when it had achieved a mean temperature of 243°C with spatial variations of ±0.4°C.Crack growth is reckoned to be stable.Surface recrystallization is presently understood to be an important factor in sliding wear.The mass flow obtained in this fashion was expected to be too high.The adverse factors of ash slagging, ash collection, and particle erosion through the boiler must be reckoned with.Русско-английский научно-технический словарь переводчика > считаться
См. также в других словарях:
Erosion — is the carrying away or displacement of solids (sediment, soil, rock and other particles) usually by the agents of currents such as, wind, water, or ice by downward or down slope movement in response to gravity or by living organisms (in the case … Wikipedia
Erosion corrosion of copper water tubes — Erosion corrosion, also known as impingement damage, is the combined effect of corrosion and erosion caused by rapid flowing turbulent water. It is probably the second most common cause of copper tube failures behind Type 1 pitting which is also… … Wikipedia
High Atlas — Geobox|Range name=High Atlas image caption=Jbel Toubkal in Toubkal National Park country=Morocco state= highest=Jbel Toubkal highest elevation=4167 highest lat d=31|highest lat m=03|highest lat s=43|highest lat NS=N highest long d=7|highest long… … Wikipedia
Ocean thermal energy conversion — Temperature differences between the surface and 1000m depth in the oceans Ocean Thermal Energy Conversion (OTEC) uses the difference between cooler deep and warmer shallow or surface ocean waters to run a heat engine and produce useful work,… … Wikipedia
agricultural technology — Introduction application of techniques to control the growth and harvesting of animal and vegetable products. Soil preparation Mechanical processing of soil so that it is in the proper physical condition for planting is usually… … Universalium
Earth Sciences — ▪ 2009 Introduction Geology and Geochemistry The theme of the 33rd International Geological Congress, which was held in Norway in August 2008, was “Earth System Science: Foundation for Sustainable Development.” It was attended by nearly… … Universalium
river — river1 riverless, adj. riverlike, adj. /riv euhr/, n. 1. a natural stream of water of fairly large size flowing in a definite course or channel or series of diverging and converging channels. 2. a similar stream of something other than water: a… … Universalium
china — /chuy neuh/, n. 1. a translucent ceramic material, biscuit fired at a high temperature, its glaze fired at a low temperature. 2. any porcelain ware. 3. plates, cups, saucers, etc., collectively. 4. figurines made of porcelain or ceramic material … Universalium
Asia — /ay zheuh, ay sheuh/, n. a continent bounded by Europe and the Arctic, Pacific, and Indian oceans. 2,896,700,000; ab. 16,000,000 sq. mi. (41,440,000 sq. km). * * * I Largest continent on Earth. It is bounded by the Arctic Ocean, the Pacific Ocean … Universalium
Wind — For other uses, see Wind (disambiguation). Wind, from the … Wikipedia
metamorphic rock — Any of a class of rocks that result from the alteration of preexisting rocks in response to changing geological conditions, including variations in temperature, pressure, and mechanical stress. The preexisting rocks may be igneous, sedimentary,… … Universalium